2, wɛ̈t ye nyuɔɔth:

KEL-RKS-18 CNC lathe otomatik feeding machineA lëu bï ya tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ɔ̈u ka tɔ̈ No noise shaking small materials no wear, one person can manipulate multiple CNC lathes, up to 8-10 sets. No noise shaking small materials no wear, one person can manipulate multiple CNC lathes, up to 8-10 sets. No noise shaking small materials no wear, one can manipulate multiple CNC lathes, up to 8-10 sets. Ka kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r ye kɛ̈ɛ̈r

6, CNC lathe oil bath feeding machine --- performance comparison (heavy hammer type simple feeding machine, oil film type feeding machine, oil bath feeding machine)

2nd step: adjust the feeder front and rear bracket to the same height, then place it at the end of the machine tool, back oil barrel rubber cover (Figure 1) is about 100mm from the lathe, the front bracket (Figure 2) center is about 900mm from the lathe (recommended distance 850-950), the rear bracket (Figure 3) and the front bracket center is about 2500mm, install the feeder chief on the front and rear bracket.

4th step: adjust the feeding machine tail bracket so that the nylon wire is in the center of the machine tool spindle hole.

5th step: adjust the feeder front bracket so that the nylon line is at the center of the feeder's supervisor's front end. Step 5: adjust the feeder's front bracket so that the nylon line is at the center of the feeder's supervisor's front end. Step 6: Calibrate repeatedly the central position of the nylon wire after confirming that there is no error, hit the 4 holes below the front and rear bracket on the expanding screw fixed.